A pinhole leak dripping inside a wall, corroded galvanized pipe finally giving out, or a slab leak that's been driving up the water bill for weeks — pipe failures range from a slow drip to a real flood. Our Howard technicians repair copper, PEX, and galvanized systems alike.
Copper, PEX, CPVC, and galvanized steel repair are all within our Howard technicians' regular scope of work.
We locate the exact leak point with detection equipment before opening any wall or slab.
An actively leaking pipe gets priority routing across Howard to limit water damage.
The price is confirmed before any cutting or repair work begins.
From a single pinhole leak to a full section of corroded galvanized pipe, our technicians match the repair to the actual damage.
We check nearby sections of pipe too, since one pinhole leak sometimes signals broader corrosion.
Copper repair work is done to match existing pipe sizing and pressure requirements.
Aging galvanized or copper systems can be converted to PEX, which resists corrosion and scale buildup better long-term.
Corroding galvanized pipe restricting water pressure gets replaced section by section or as a full re-pipe, depending on extent.
Electronic leak detection locates the exact point of a slab leak before any concrete is opened.
A pipe that froze and split gets repaired or replaced, along with recommendations to prevent a repeat freeze.
Describe the leak symptoms to dispatch — visible water, a wet spot, or just a rising water bill all point to different urgency levels.
A technician arrives with detection and repair equipment matched to your pipe material.
The leak is located precisely, the repair scope explained, and a flat price quoted before any cutting begins.
We test the repair under normal water pressure before calling the job done, then back it in writing.
"Slab leak located with equipment before they cut into the floor. Kept the repair small." — Homeowner, Howard
"Frozen pipe burst over a cold weekend, they repaired it and suggested insulation to prevent a repeat." — Howard resident
"Soldered joint repair was clean work, no leaks since, and reasonably priced." — Howard customer
Our pipe repair technicians cover Howard and the surrounding Howard, WI area, with detection equipment on every truck.
We locate the leak first, which keeps the repair opening small and targeted.
We'll assess the extent and give you honest numbers on spot repair versus full replacement.
Both are solid choices — we can walk through the tradeoffs for your specific situation.
Cost depends on leak location and accessibility; we'll quote a flat price once the leak is located.
Often yes — a single burst section can usually be spot-repaired rather than replacing the whole line.
We aim to minimize the opening required, though every slab leak is assessed individually.
Fast dispatch across Howard, WI for active leaks.
Call +1-855-718-1500